CGP Electronics TP-42 Specifikace stáhnout pdf (Strana 43)

Figure 20: Female Modem Cable Connector: EOL Set to In

Modem Set EOL to Out

To set the modem with the end-of-line selection set to Out, wire the 9-pin connector using solder connections as in

Figure 21.

Note: The following figure shows the 9-pin female connector. The pin numbers on the 9-pin male connector are

reversed.

Figure 21: Female Modem Cable Connector: EOL Set to Out

Table 15: EOL Connections Summarized

For Non-EOL SelectionFor EOL SelectionFC Bus Signal

Terminal 3Terminal 7, Jumper 7-3FC +

Terminal 9Terminal 8, Jumper 8-9FC -

Terminal 1 or 5Terminal 1 or 5REF

Tape BackTape BackSHIELD

43MS/TP Communications Bus Technical Bulletin: Appendix: FC Bus Auxiliary Devices

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 58 59

Žádné komentáře

CGP Electronics TP-42 Specifikace Strana 43